Airbag control unit with part number 95910-1G210

What does the airbag control unit 95910-1G210 do?

The airbag control unit 95910-1G210 controls the restraint system (SRS) of Kia. It measures the signals from the crash sensors, determines in a crash which airbags and seatbelt pretensioners are triggered, and monitors the system permanently. Faults it finds are shown via the airbag warning light.

The calculation runs inside the unit itself, so that the decision is made in time.

After an accident it stores crash data and locks itself. This is a fixed behaviour of the unit.

Why does the control unit 95910-1G210 fail?

The most common cause with the 95910-1G210 is crash data stored after an accident, even if no airbag fired. A normal diagnostic tool cannot delete this data. Besides that, aged components, cold solder joints, moisture, corrosion and voltage spikes come into question as causes.

Crash data stays in the memory regardless of whether an airbag fired. The fault memory shows the entry, but a diagnostic tool does not remove it.

The further causes include, in detail:

• aged electronic components
• cold solder joints
• moisture and corrosion at plug connections
• voltage spikes, for example from a weak battery or jump starting

How can you tell that the 95910-1G210 is defective?

An airbag warning light that stays on permanently or intermittently is the first sign of a defect on the 95910-1G210. In addition there are error messages, a missing contact with the diagnostic tool and a fault memory that cannot be cleared.

The warning light is the most direct hint the vehicle gives itself. It shows the state of the restraint system without any further measurement.

While a fault exists, airbags and seatbelt pretensioners may possibly not trigger in an emergency. A prompt check is therefore sensible.

Which vehicles is the 95910-1G210 fitted in?

The control unit 95910-1G210 is fitted in these vehicles: Kia Rio JB (2005-2011).

The assignment to the models is listed here:

• Kia Rio JB (2005-2011)

Compare the part number on the label with this page, then you know that the unit fits. Have the fault memory read out beforehand, because only the log shows whether the control unit itself is affected or a connector or cable.

For the same vehicles, we also repair control units with the part numbers 95910-1G150, 959101W200, 959101W600, 959101W610.

How does the repair of the 95910-1G210 work?

For the 95910-1G210 first have the fault memory read out and the log made. Then disconnect the battery and only afterwards remove the control unit. Then create the repair order online and send in the well-packed unit.

At Airbag24 the team checks the unit on the test bench, replaces defective components and removes the crash data. A function test follows. Processing usually takes 3–4 working days, after which your own unit goes back to you.

Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-1G210 get to Airbag24?

You send the control unit 95910-1G210 as a parcel, or you book a UPS collection for an extra charge. After the repair Airbag24 returns it by UPS. The printed repair order goes into the parcel, and the unit is packed shock-proof.

Padding around the unit prevents knocks inside the box.