Airbag control unit with part number 95910-1R050

What does the airbag control unit 95910-1R050 do?

The 95910-1R050 controls the restraint system (SRS) of Hyundai as the airbag control unit. It processes the measured values of the crash sensors and decides in an emergency within milliseconds which airbags and seatbelt pretensioners are triggered.

During operation the unit checks continuously whether all components of the system are working correctly. It reports faults it finds via the airbag warning light.

Monitoring stays active even when the vehicle is just standing. After an accident the unit stores crash data and then locks itself.

Why does the control unit 95910-1R050 fail?

Stored crash data is the most common cause for the 95910-1R050, even if no airbag has deployed. Other causes include aged electronic components, cold solder joints, moisture and corrosion on plug connections, and voltage spikes.

A normal diagnostic tool cannot erase this crash data. Airbag24 removes it during the repair, as soon as the unit has arrived and been checked.

Electronics age, connections corrode, and voltage spikes from the vehicle electrical system can stress components, even without a prior accident. Which of these applies cannot be determined reliably from outside, so the check is part of the process.

How can you tell that the 95910-1R050 is defective?

The airbag warning light in the instrument cluster lights up permanently or intermittently when the 95910-1R050 is defective. An error message also appears, and the fault memory cannot be cleared.

In addition, the diagnostic tool cannot establish a connection to the control unit. This too points to a problem that needs to be checked.

In an emergency, airbags and seatbelt pretensioners may not trigger. Do not ignore the warning light.

Which vehicles is the 95910-1R050 fitted in?

The 95910-1R050 is fitted in these vehicles: Hyundai Accent RB (2010-2017).

The assignment of vehicles to this control unit is listed below.

• Hyundai Accent RB (2010-2017)

Compare the part number on the label of the removed unit with this page, so that you can be sure you have the right unit. Also have the fault memory read out, because only this result shows whether the control unit is defective or whether a plug or a cable is the cause.

For the same vehicles, we also repair control units with the part numbers 95910-1R250, 95910-25200, 95910-25500.

How does the repair of the 95910-1R050 work?

Have the fault memory read out and the log enclosed before the battery is disconnected. Only then do you remove the 95910-1R050 and create a repair order online. Processing at Airbag24 usually takes 3–4 working days.

Airbag24 checks the control unit on the test bench, replaces defective components where necessary, erases the stored crash data and carries out a function test. Afterwards the unit goes back to you.

Our repairs come with 2 years' statutory liability for defects.

The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-1R050 get to Airbag24?

You send the unit as a parcel or book a UPS collection for an extra charge. After the repair, Airbag24 sends the 95910-1R050 back to you by UPS.

Put the printed repair order into the parcel and pack the control unit shock-proof.