Airbag control unit with part number 95910-1W410

What does the airbag control unit 95910-1W410 do?

The airbag control unit 95910-1W410 is the control unit of the restraint system (SRS) for Kia. It receives the reports from the crash sensors, evaluates them within milliseconds and decides which airbags and seatbelt pretensioners are triggered. After an accident, it stores crash data and locks itself; only the repair lifts this lock.

In addition, the unit monitors the entire system. It shows detected faults via the airbag warning light in the instrument cluster.

It is worth keeping an eye on this light, because it is the direct feedback from the system to the driver.

Why does the control unit 95910-1W410 fail?

The most common cause is crash data stored after an accident, even if no airbag has deployed; a normal diagnostic tool cannot remove it. Other causes are aged electronic components, cold solder joints, moisture and corrosion at plug connections, and voltage peaks.

Crash data is created in the memory of the control unit. It remains there even if you use the vehicle normally after the accident, and reading it out only makes it visible.

The other causes relate to ageing and environmental influences. Electronic components age, solder joints can break, and moisture attacks the contacts. Voltage peaks, for example from a weakened battery or a jump start, put additional strain on the electronics.

How can you tell that the 95910-1W410 is defective?

A defect shows up through the airbag warning light in the instrument cluster, which stays on permanently or intermittently, and through error messages. A fault memory that cannot be cleared, or a diagnostic tool without contact to the control unit, indicates a defect. Airbags and seatbelt pretensioners may then possibly fail to trigger in an emergency.

Watch for these signs:

• airbag warning light on permanently or intermittently
• error message in the instrument cluster
• fault memory cannot be cleared
• diagnostic tool has no connection to the control unit

The light shows the finding as soon as the control unit detects a fault.

Which vehicles is the 95910-1W410 fitted in?

The control unit 95910-1W410 is fitted in these vehicles: Kia Rio UB (2011-2017).

This overview shows whether your own vehicle is listed.

• Kia Rio UB (2011-2017)

Comparing the part number on the label of the removed unit with this page only confirms that it is the matching unit. Whether the control unit is defective or a plug or cable is the cause is shown by the fault memory, which you should have read out beforehand.

For the same vehicles, we also repair control units with the part numbers 0K32B677F0, 95910-0W500, 95910-1W100, 95910-1W500, 95910-1W510, 959101G900.

How does the repair of the 95910-1W410 work?

First have the fault memory read out and attach the log. Then disconnect the battery and afterwards remove the unit. Create the repair order online and pack the well-packed unit for sending. Airbag24 generally allows 3–4 working days for this.

Airbag24 tests the unit on the test bench and then repairs defective components. Stored crash data are erased before a function test follows.

Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-1W410 get to Airbag24?

Either you send the control unit 95910-1W410 in as a parcel, or you book a UPS collection for an extra charge. The return shipment after the repair is handled by UPS.

Put the printed repair order into the parcel and pack the unit shockproof.