Airbag control unit with part number 95910-2E710

What does the airbag control unit 95910-2E710 do?

The airbag control unit 95910-2E710 controls the SRS restraint system in Hyundai vehicles. It checks the sensor signals, calculates the trigger timing for airbags and seatbelt pretensioners in a crash, and monitors the system continuously. Any faults found are reported to the airbag warning light.

The crash sensors supply the raw data; the control unit makes the decision.

If an accident occurs, crash data is stored and the unit locks itself.

Why does the control unit 95910-2E710 fail?

The most common cause is crash data left in memory after an accident, whether or not airbags fired. Other causes include ageing of the electronics, cold solder joints, wetness at the connectors, corrosion and voltage spikes in the on-board network.

• aged electronic components
• cold solder joints
• moisture and corrosion at plug connections
• voltage spikes in the on-board network

Crash data cannot be removed with an ordinary diagnostic tool. Airbag24 takes care of this as part of the repair.

Which of the other points applies is only decided by examining the unit.

How can you tell that the 95910-2E710 is defective?

Start with the airbag warning light in the instrument cluster, which stays on permanently or intermittently. It may be accompanied by a fault message in the instrument cluster, a missing connection between the diagnostic tool and the control unit, and a fault memory that cannot be cleared.

The light indicates that airbags and seatbelt pretensioners may fail to deploy in an emergency. Such a condition cannot be fixed by yourself.

Therefore have the warning looked at promptly.

Which vehicles is the 95910-2E710 fitted in?

The control unit 95910-2E710 is fitted in these vehicles: Hyundai Tucson JM (2004-2010).

Below is the assignment of the models recorded for this unit:

• Hyundai Tucson JM (2004-2010)

Match the number on the label of the removed unit with this page. This shows you whether it is the right unit. You should have the fault memory read out beforehand, because only the log shows whether the control unit or a connector or cable is causing the fault.

For the same vehicles, we also repair control units with the part numbers 44B49060NAS, 95910-2E400, 95910-2E700, 959102S500, 959102S850.

How does the repair of the 95910-2E710 work?

First have the fault memory read out and enclose the log, then disconnect the battery and only then remove the control unit. Afterwards create the repair order online and send in the unit well packed. Airbag24 usually needs 3–4 working days for inspection, repair and testing.

The technicians at Airbag24 check the unit on the test bench, replace faulty components, remove the crash data and finish with a function test. Your unit is then returned to you.

Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-2E710 get to Airbag24?

Either you post the unit as a parcel or book a collection by UPS for an extra charge. After the repair, Airbag24 brings the unit back to you by UPS. You enclose the printed repair order with the parcel.

Make sure the packaging is shock-resistant so that the unit arrives safely.