Airbag control unit with part number 95910-2S600

What does the airbag control unit 95910-2S600 do?

The airbag control unit 95910-2S600 controls the restraint system (SRS) in the Hyundai vehicle. It checks the signals from the crash sensors, decides in an accident whether airbags and seatbelt pretensioners fire, and monitors the system during operation. After an accident it stores crash data and locks itself.

The decision in a crash falls within milliseconds, which is why the evaluation takes place in the control unit itself.

The unit reports faults via the airbag warning light in the instrument cluster, so the condition of the system remains visible to you.

Why does the control unit 95910-2S600 fail?

The most frequent cause is crash data stored after an accident, even if no airbag has deployed at all. A conventional diagnostic tool cannot erase it; Airbag24 erases it during the repair. Other causes are aged electronic components, cold solder joints, moisture and corrosion at plug connections, and voltage spikes, for example with a weak battery or jump-starting.

It is easy to overlook that crash data remains in memory after an accident without a deployed airbag. An earlier incident can therefore fall into oblivion without anyone noticing.

The other causes concern electronics and contacts: moisture and corrosion weaken plug connections, voltage spikes stress the components, and aged solder joints can fail.

How can you tell that the 95910-2S600 is defective?

A defect shows when the airbag warning light in the instrument cluster lights up continuously or intermittently. In addition there may be an error message in the instrument cluster, no connection to the diagnostic tool, and a fault memory that cannot be cleared.

As long as the warning light is active, airbags and seatbelt pretensioners may not deploy in an emergency. A diagnostic tool that makes no contact with the control unit is a clear sign of disturbed communication.

Which point is responsible only becomes clear through the inspection. Until then, caution is advised.

Which vehicles is the 95910-2S600 fitted in?

This part number belongs to Hyundai vehicles. The control unit 95910-2S600 is fitted in these vehicles: Hyundai ix35 LM (2009-2013) and LM Facelift (2013-2015).

Here follows the overview:

• Hyundai ix35 LM (2009-2013)
• Hyundai ix35 LM Facelift (2013-2015)

Comparing the part number on the label with this page confirms that you have removed the correct unit. However, this does not clarify the cause. For that the fault memory read out beforehand is needed, because it shows whether the control unit itself is defective or whether a plug or cable is affected.

For the same vehicles, we also repair control units with the part numbers 95910-2S000, 95910-2S100, 95910-2S150, 95910-2S200, 95910-2S250, 95910-2S350.

How does the repair of the 95910-2S600 work?

First have the fault memory read out and attach the log to your order. Then disconnect the battery and remove the control unit. Afterwards create a repair order online and send the unit in well packed.

Airbag24 checks the unit on the test bench, replaces defective components, erases stored crash data and carries out a function test. Only after that is your own unit returned to you.

Processing at Airbag24 usually takes 3–4 working days. This time applies only to checking, repairing and testing and not to your steps or the shipping.

Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-2S600 get to Airbag24?

You send the unit as a parcel or arrange a UPS collection for an extra charge. Airbag24 sends it back to you by UPS after the repair.

Packed shock-proof and with the printed repair order in the box, the unit is properly prepared.