Airbag control unit with part number 95910-2V450

What does the airbag control unit 95910-2V450 do?

The airbag control unit 95910-2V450 coordinates the SRS restraint system in the Hyundai. It continuously checks the signals from the crash sensors and decides in an accident which airbags and seatbelt pretensioners are triggered. This decision is made within fractions of a second.

The unit reports irregularities via the airbag warning light in the instrument cluster. In this way you as the driver recognise that something is wrong in the restraint system.

After an accident the control unit writes crash data into its memory and locks itself. The lock is only lifted by the repair.

Why does the control unit 95910-2V450 fail?

Stored crash data from an accident is the most common cause, even if no airbag was triggered. An ordinary diagnostic tool does not erase it. Aged components, cold solder joints, moisture at plugs and voltage spikes can also lead to failure.

Crash data cannot be removed by yourself in everyday use. Airbag24 erases it during the repair.

The other causes lie in the electronics or in the connections: components age, solder joints can go cold, moisture and corrosion attack plugs, and voltage spikes occur, for example with a weak battery or a jump start.

How can you tell that the 95910-2V450 is defective?

A defect shows itself through the airbag warning light, which stays on continuously or intermittently, through a fault message in the instrument cluster, through a diagnostic tool that cannot make contact with the control unit, and through a fault memory that cannot be cleared.

The system reports the fault because it recognises it itself. In an emergency, airbags and seatbelt pretensioners may then fail to trigger.

Driving without any noticeable problems is no proof of an intact system; only the fault memory provides information on that.

Which vehicles is the 95910-2V450 fitted in?

The 95910-2V450 is fitted in these vehicles: Hyundai Veloster FS (2011-2018).

Which models belong to this part number is shown in the next list.

• Hyundai Veloster FS (2011-2018)

Comparing the part number on the label of the removed unit with this page only confirms that it is the right unit. Whether the control unit itself is the cause is only shown by the fault memory read out, which you should therefore have read out beforehand.

For the same vehicles, we also repair control units with the part numbers 28400435, 95910-2V030, 95910-2V350, 95910-K9100.

How does the repair of the 95910-2V450 work?

First have the fault memory read out and enclose the log. Then disconnect the battery, and only afterwards remove the control unit. Next, create a repair order online and send in the well-packed unit.

On the test bench the unit is checked, defective components are replaced, stored crash data is erased and a function test is carried out. Processing takes 3–4 working days.

Afterwards your own unit is returned to you. Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-2V450 get to Airbag24?

You send the unit as a parcel or book a UPS collection for an extra charge. Airbag24 sends the repaired unit back to you by UPS afterwards.

The printed repair order goes into the parcel, and the unit is packed shockproof.