Airbag control unit with part number 95910-2Z600

What does the airbag control unit 95910-2Z600 do?

The airbag control unit 95910-2Z600 is the control unit of the restraint system (SRS) in Hyundai vehicles. It evaluates the crash sensors, decides in an accident within milliseconds whether airbags and seatbelt pretensioners are triggered, and monitors the entire system. It reports faults via the airbag warning light.

The evaluation runs without interruption. After an accident the unit stores crash data and then locks itself.

Why does the control unit 95910-2Z600 fail?

The most common cause is the stored crash data that arises after an accident, even if no airbag has deployed. An ordinary diagnostic tool cannot erase it. Further causes are aged electronic components, cold solder joints, moisture and corrosion at plug connections, and voltage spikes, for example from a weak battery or a jump start.

Whether an airbag has deployed does not determine whether data remains in the memory. Airbag24 removes the crash data as part of the repair.

The other causes concern the electronics and their connections. Aged components, cold solder joints and corrosion at plugs disturb signal transmission, and voltage spikes stress the components. Only the inspection shows which cause applies.

How can you tell that the 95910-2Z600 is defective?

The airbag warning light in the instrument cluster lights up permanently or intermittently. In addition, an error message appears in the instrument cluster, the diagnostic tool gets no connection to the control unit, or the fault memory cannot be cleared.

In the event of a defect, the airbags and seatbelt pretensioners may possibly not deploy in an emergency. If the warning light indicates a fault, have the vehicle checked.

Which vehicles is the 95910-2Z600 fitted in?

The control unit 95910-2Z600 is fitted in these vehicles: Hyundai ix35 LM (2009-2013) and LM Facelift (2013-2015).

The vehicles concerned are listed here:

• Hyundai ix35 LM (2009-2013)
• Hyundai ix35 LM Facelift (2013-2015)

Comparing the part number on the label of the removed unit with this page only ensures that you have the right unit in front of you. Have the fault memory read out beforehand, because only the log shows whether the control unit itself or a plug or cable is the cause.

For the same vehicles, we also repair control units with the part numbers 95910-2Y100, 95910-2Y200.

How does the repair of the 95910-2Z600 work?

First the fault memory is read out and the log is enclosed. Then the battery is disconnected and only afterwards is the control unit removed. You then create the repair order online and send the well-packed unit in. Processing at Airbag24 usually takes 3–4 working days.

Airbag24 checks the unit on the test bench, replaces defective components and erases stored crash data. A functional test follows, after which your own unit is sent back.

Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-2Z600 get to Airbag24?

You send the control unit as a parcel to us or book a UPS collection for an extra charge. After the repair Airbag24 sends the unit back to you by UPS.

Enclose the printed repair order in the parcel and pack the unit shockproof.