Airbag control unit with part number 95910-3V200

What does the airbag control unit 95910-3V200 do?

At Hyundai, the airbag control unit 95910-3V200 takes over control of the restraint system (SRS). It reads the crash sensors, decides in an impact which airbags and seatbelt pretensioners trigger, and checks the system continuously. It reports faults via the airbag warning light.

The check is not limited to emergencies. Even during normal driving, the unit evaluates the measured values and reports deviations.

After an accident the unit stores crash data and locks itself. Only the repair lifts this lock.

Why does the control unit 95910-3V200 fail?

The most common cause on the 95910-3V200 lies in crash data that an accident has left behind, even without a triggered airbag. A standard diagnostic tool cannot reach it. Aged components, cold solder joints, moisture at plug connections and voltage spikes come on top.

An impact without airbag deployment can leave crash data behind. This data stays in the unit until the repair takes place.

The other causes act slowly over time. Electronics age, solder joints can give way, and moisture attacks the plug connections. Voltage spikes, for example from a weak battery or jump-starting, additionally stress the unit.

How can you tell that the 95910-3V200 is defective?

You recognise a defect on the 95910-3V200 by the airbag warning light in the instrument cluster, which lights up permanently or intermittently, by an error message, or by a diagnostic tool without connection to the control unit. A fault memory that cannot be cleared confirms this. In an emergency, airbags and seatbelt pretensioners may then possibly fail to deploy.

The warning light is the signal the vehicle gives itself. Anyone who follows it up and has the fault memory read out clarifies the situation early.

If the connection to the diagnostic tool fails, the cause is not immediately clear, because it may lie in the control unit or in the wiring. The read-out separates the two.

Which vehicles is the 95910-3V200 fitted in?

Which model fits is determined by the part number on the unit. The airbag control unit 95910-3V200 is fitted at Hyundai in these vehicles: Hyundai Grandeur HG (2011-2017).

The list contains the assigned models:

• Hyundai Grandeur HG (2011-2017)

Two points belong before removal. Compare the part number on the unit with this page, so that you can be sure it is the right unit. Have the fault memory read out beforehand; only then does it show whether the control unit is defective or whether a plug or cable is the cause.

For the same vehicles, we also repair control units with the part numbers 95910-3V000, 95910-3V250, 95910-E7000.

How does the repair of the 95910-3V200 work?

You begin by reading out the fault memory at the 95910-3V200 and attach the log. In the next step you disconnect the battery; only then do you remove the control unit. Online you create the repair order, and processing at Airbag24 usually takes 3–4 working days.

Then you pack the unit well and send it. Airbag24 checks it on the test bench, replaces defective components, erases stored crash data and runs the function test. Finally your own unit goes back to you.

Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-3V200 get to Airbag24?

Either you send the control unit 95910-3V200 as a parcel, or you arrange a UPS collection for an extra charge. The return to you after the repair is made via UPS.

The printed repair order goes into the parcel, together with shock-proof packaging for the control unit.