Airbag control unit with part number 95910-3X060

What does the airbag control unit 95910-3X060 do?

The airbag control unit 95910-3X060 is the control unit of the SRS in the Hyundai. It records the readings of the crash sensors, determines in the event of an accident which airbags and seatbelt pretensioners fire, and checks the entire restraint system without interruption.

If a component fails or a fault is present, the unit shows it via the airbag warning light in the instrument cluster.

After an accident it writes crash data to its memory and locks itself. The lock is only ended by a repair.

Why does the control unit 95910-3X060 fail?

After an accident, stored crash data is the most frequent cause of failure, even if no airbag fired. A commercially available diagnostic tool cannot erase this data. Aged electronics, moisture at plug connectors, cold solder joints and voltage spikes are also possible causes.

Without intervention the data therefore remains, and Airbag24 removes it during the repair.

Aged electronic components, cold solder joints, moisture and corrosion at plug connectors, as well as voltage spikes, for example from a weak battery or a jump start, are further reasons that come into consideration.

How can you tell that the 95910-3X060 is defective?

A defect shows itself through the airbag warning light, which stays on permanently or flashes intermittently, through a fault message in the instrument cluster, through a diagnostic tool that cannot make a connection, and through a fault memory that cannot be cleared.

In an emergency, airbags and seatbelt pretensioners may possibly not trigger with a defective control unit. Normal driving behaviour says nothing about this, which is why the fault memory is decisive.

Which vehicles is the 95910-3X060 fitted in?

The 95910-3X060 is fitted in these vehicles: Hyundai Elantra MD.

The list below names the vehicles that are recorded for this part number.

• Hyundai Elantra MD

Comparing the part number on the label of the removed unit with this page only confirms that it is the right unit. Have the fault memory read out beforehand, because it shows whether the control unit itself is defective or whether a plug or cable is the cause.

For the same vehicles, we also repair control units with the part numbers 95910-3X100, 95910-A5150.

How does the repair of the 95910-3X060 work?

First you read out the fault memory and enclose the log. Then you disconnect the battery and only then remove the control unit. Next, create a repair order online and pack the unit carefully for dispatch.

Airbag24 checks the unit on the test bench, replaces defective components and erases the stored crash data. A function test follows, and the processing takes 3–4 working days.

Afterwards your own unit goes back to you. Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-3X060 get to Airbag24?

You send the control unit as a parcel or book a UPS collection for an extra charge. Airbag24 sends it back to you by UPS after the repair.

The printed repair order goes into the parcel, and you pack the unit shockproof.