Airbag control unit with part number 95910-4D430

What does the airbag control unit 95910-4D430 do?

Within the restraint system (SRS) of Kia, the airbag control unit 95910-4D430 is the point where the signals from the crash sensors come together. In a crash, it decides within a few milliseconds which airbags and seatbelt pretensioners are triggered.

It also checks the system continuously and reports faults via the airbag warning light in the instrument cluster.

After an accident, it saves crash data and remains locked afterwards.

Why does the control unit 95910-4D430 fail?

The most common cause is crash data from an accident that remains in the unit, even if no airbag has been triggered; a normal diagnostic tool cannot remove it. Other causes are ageing components, cold solder joints, moisture and corrosion at plugs, and voltage spikes.

This recording stays in the unit until it is removed during the repair.

Ageing components and solder joints that have gone cold disrupt signal transmission.

Moisture and corrosion act on plug connections, and voltage spikes, for example with a weak battery or jump-starting, put strain on the electronics.

How can you tell that the 95910-4D430 is defective?

A defect is evident when the airbag warning light in the instrument cluster stays on permanently or intermittently, a fault message appears, the diagnostic tool cannot establish a connection, or the fault memory cannot be cleared. In an emergency, the airbags and seatbelt pretensioners may then fail to trigger.

The light is a direct report from the system and should therefore be taken seriously.

A prompt check is then advisable.

Which vehicles is the 95910-4D430 fitted in?

The 95910-4D430 is fitted in these vehicles: Kia Carnival VQ (2005-2014).

The following vehicles are recorded for this part number:

• Kia Carnival VQ (2005-2014)

Comparing the part number on the label of the removed unit with this page confirms that the unit is the right one. The fault memory, on the other hand, shows whether the control unit is defective or whether a plug or cable is the cause. Please have it read out beforehand.

For the same vehicles, we also repair control units with the part numbers 4D959-10640, 95910-4D640, 95910-R0100.

How does the repair of the 95910-4D430 work?

First, have the fault memory read out and enclose the log. Then disconnect the battery, and only after that remove the control unit. Next, create the repair order online and send in the well-packed unit.

Airbag24 first checks the unit on the test bench. Afterwards, defective components are replaced, the crash data is erased and a functional test is carried out, and then your own unit is returned. Processing usually takes 3–4 working days.

Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-4D430 get to Airbag24?

You can send the unit as a parcel or book a UPS collection for an extra charge. After the repair, Airbag24 sends it back to you by UPS.

Enclose the printed repair order and pack the control unit shock-proof.