Airbag control unit with part number 95910-A2300

What does the airbag control unit 95910-A2300 do?

The airbag control unit 95910-A2300 coordinates the restraint system (SRS) in the Kia. It evaluates the crash sensors, determines in an accident which airbags and seatbelt pretensioners are triggered, and checks the system constantly. After an accident it stores crash data and locks itself.

The unit shows detected faults via the airbag warning light, which sits in the instrument cluster. The entire sensor system converges in this unit.

Why does the control unit 95910-A2300 fail?

The most frequent cause is stored crash data, even if no airbag was triggered; a normal diagnostic tool does not remove it. In addition there are aged electronics, cold solder joints, moisture and corrosion at plugs, and voltage spikes, for example from a weak battery or jump starting.

The crash data remains in the memory after the event until Airbag24 deletes it during the repair.

The further causes at a glance:

• aged electronic components
• cold solder joints
• moisture and corrosion at plug connections
• voltage spikes, for example from a weak battery or jump starting

How can you tell that the 95910-A2300 is defective?

The airbag warning light in the instrument cluster stays on permanently or intermittently, error messages appear there, and the diagnostic tool cannot reach the control unit. If the fault memory cannot be cleared, this confirms the finding. Then airbags and seatbelt pretensioners may fail to trigger in an emergency.

The airbag warning light is the most direct indication the restraint system gives. It shows that the system has detected a fault and therefore cannot be ignored.

Which vehicles is the 95910-A2300 fitted in?

The 95910-A2300 is fitted in these vehicles: Kia cee'd JD (2012-2018).

The assignment to vehicles is shown in this list:

• Kia cee'd JD (2012-2018)

Compare the part number on the label of the removed unit with this page; that only clarifies the question of the right unit. Also have the fault memory read out beforehand, because only its contents show whether the control unit or a plug or cable is the cause.

For the same vehicles, we also repair control units with the part numbers 95910-1H000, 95910-A2100, 95910-A2320, 95910-A2750.

How does the repair of the 95910-A2300 work?

First attach the log of the read-out fault memory, then disconnect the battery and remove the control unit. Then create the repair order online and pack the unit well. At Airbag24, checking, repairing and testing usually take 3–4 working days.

At Airbag24 the control unit is checked on the test bench, defective components are replaced, the crash data is deleted and a function test is carried out. The unit then returns to you.

Our repairs come with 2 years' statutory liability for defects.

The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-A2300 get to Airbag24?

Either you send the unit as a parcel, or you book a UPS collection for an extra charge. Airbag24 returns the repaired unit by UPS.

The printed repair order belongs in the parcel. Pack the control unit shockproof so it arrives undamaged.