Airbag control unit with part number 95910-AT150

What does the airbag control unit 95910-AT150 do?

The airbag control unit 95910-AT150 is the central unit of the restraint system (SRS) in Kia. It evaluates the sensor signals of a crash in milliseconds and determines which airbags and seatbelt pretensioners are triggered; at the same time it checks the system for faults continuously.

If the system reports a fault, it appears via the airbag warning light in the instrument cluster. For you, this light is therefore the first indication.

After an accident, the unit stores crash data and then locks itself.

Why does the control unit 95910-AT150 fail?

For the 95910-AT150, the most common cause is crash data stored after an accident, even if no airbag was triggered. Other possible causes are ageing electronic components, cold solder joints, moisture and corrosion on plug connections, and voltage spikes.

The stored crash data cannot be erased with an ordinary diagnostic tool. Airbag24 removes it during the repair.

The other causes lie in the electronics themselves or in their surroundings. Ageing components lose reliability over time, and cold solder joints can cause contact problems.

Moisture reaches the contacts via plug connections and causes corrosion there. Voltage spikes arise, for example, from a weak battery or when a jump start is connected.

How can you tell that the 95910-AT150 is defective?

A defect on the 95910-AT150 shows up at the airbag warning light, in a fault message in the instrument cluster, in a diagnostic tool with no connection to the control unit, or in a fault memory that cannot be cleared. In an emergency, airbags and seatbelt pretensioners may then not trigger.

The airbag warning light in the instrument cluster is the first warning signal. If it lights up permanently or only intermittently, it must be taken seriously.

If the diagnostic tool cannot establish a connection to the control unit, that is a further indication. Likewise, a fault memory that cannot be reset points to a fault.

Which vehicles is the 95910-AT150 fitted in?

The 95910-AT150 is fitted in these vehicles: Kia Niro SG2 (from 2022).

The vehicles recorded for this part number follow below.

• Kia Niro SG2 (from 2022)

First compare the number on the label of the removed control unit with this page. This only confirms that it is the right unit. Then have the fault memory read out, as only this shows whether the control unit is defective or whether a plug or cable is the cause.

For the same vehicles, we also repair control units with the part numbers 95910-Q4000, Q4959-10000.

How does the repair of the 95910-AT150 work?

You have the fault memory of the 95910-AT150 read out first and attach the log. Then you disconnect the battery; only after that do you remove the control unit. Then you create a repair order online and send the unit in well packed.

Airbag24 tests the unit on the test bench, repairs defective components and carries out a function test. Airbag24 also erases stored crash data. The testing, repairing and checking at Airbag24 usually takes 3–4 working days.

Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-AT150 get to Airbag24?

You send the 95910-AT150 to Airbag24 as a parcel, or alternatively book a UPS collection for an extra charge. Return shipment after the repair is by UPS.

Enclose the printed repair order with the parcel, and pack the unit shockproof.