Airbag control unit with part number 95910-CL200

What does the airbag control unit 95910-CL200 do?

The airbag control unit 95910-CL200 manages the restraint system (SRS) in Hyundai vehicles. It analyses the crash sensors, decides in a collision on the triggering of airbags and seatbelt pretensioners, and monitors the system without interruption.

The decision must be made in fractions of a second. The unit therefore works with its own test routines, which run continuously.

It shows detected faults via the airbag warning light in the instrument cluster. After an accident, it stores crash data and locks itself. Only the repair lifts the lock.

Why does the control unit 95910-CL200 fail?

The most common cause is crash data from an accident that stays in the memory, even if no airbag was triggered. Further causes are ageing of the electronics, cold solder joints, moisture, corrosion and voltage spikes.

A standard diagnostic tool does not erase crash data; Airbag24 removes it during the repair. The other causes at a glance:

• Ageing of electronic components
• Cold solder joints
• Moisture and corrosion at plug connections
• Voltage spikes, for example from a weak battery or a jump start

How can you tell that the 95910-CL200 is defective?

A defect in the 95910-CL200 becomes apparent through the airbag warning light, which stays on permanently or intermittently, as well as through fault messages in the instrument cluster, a missing connection to the diagnostic tool, or a fault memory that cannot be cleared. In an emergency, airbags and seatbelt pretensioners may then not trigger.

The system therefore requires a check as soon as one of these signs appears.

A diagnostic tool that cannot establish a connection also indicates a fault that needs to be clarified. The warning light and the message are the signs that the vehicle gives itself.

Which vehicles is the 95910-CL200 fitted in?

The 95910-CL200 is fitted in these vehicles: Hyundai Santa Fe TM Facelift (2020-2024).

The assigned vehicles are listed here:

• Hyundai Santa Fe TM Facelift (2020-2024)

Comparing the part number on the label of the removed unit with this page only confirms that you have the right unit in front of you. Whether the control unit is defective or a connector or cable is the cause is shown only by the fault memory that you have read out.

For the same vehicles, we also repair control units with the part numbers 95910-2B600, 95910-2B610, 95910-2B620, 95910-2B650, 95910-2B970.

How does the repair of the 95910-CL200 work?

First, read out the fault memory and enclose the log, then disconnect the battery. Only after that remove the control unit and create a repair order online. Send the unit in well packed.

Processing at Airbag24 usually takes 3–4 working days. During this time, the unit is examined on the test bench, defective components are repaired, the crash data is erased and a function test is carried out.

Afterwards, your own unit is returned to you.

Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-CL200 get to Airbag24?

You send the 95910-CL200 control unit to Airbag24 as a parcel, or you book a UPS collection for an extra charge. After the repair, it is returned by UPS.

Put the printed repair order into the parcel and pack the control unit so that it is shock-resistant.