Airbag control unit with part number 95910-F6200

What does the airbag control unit 95910-F6200 do?

The airbag control unit 95910-F6200 controls the restraint system (SRS) of Kia. It evaluates the crash sensors and triggers airbags and seatbelt pretensioners in an accident.

The sensors supply the control unit with measured values continuously. From these it determines within milliseconds whether an event has occurred that requires the restraint systems to trigger. Between events it also monitors the wiring and the firing circuits.

Detected faults are reported by the device via the airbag warning light in the instrument cluster. After an accident it stores crash data and locks itself.

Why does the control unit 95910-F6200 fail?

The most common cause for the control unit 95910-F6200 is crash data from an earlier accident, even if no airbag deployed in it. Other causes are aged electronic components, cold solder joints, moisture and corrosion on plug connections, and voltage spikes.

Crash data cannot be erased with an ordinary diagnostic tool. The repair at Airbag24 therefore removes it in a targeted way.

In addition, the following causes are possible:

• aged electronic components
• cold solder joints
• moisture and corrosion on plug connections
• voltage spikes, for example from a weak battery or a jump start

How can you tell that the 95910-F6200 is defective?

A defect on the 95910-F6200 shows itself through the airbag warning light in the instrument cluster, which lights up constantly or intermittently. Fault messages, connection problems with the diagnostic tool, or a fault memory that cannot be cleared are added to this.

• Airbag warning light in the instrument cluster lights up
• Fault message in the instrument cluster
• Diagnostic tool cannot establish a connection to the control unit
• Fault memory cannot be cleared

In an emergency, airbags and seatbelt pretensioners may then not deploy. A prompt check of the system is therefore advisable.

Which vehicles is the 95910-F6200 fitted in?

The control unit 95910-F6200 is fitted in these vehicles: Kia Cadenza VG (2009-2016).

The vehicles in which this unit is fitted are listed below:

• Kia Cadenza VG (2009-2016)

Compare the part number on the label of the removed unit with this page. This only confirms that you have the right unit in front of you. Also have the fault memory read out beforehand, because only this result shows whether the control unit is defective or whether a plug or a cable is the cause.

For the same vehicles, we also repair control units with the part numbers 95910F6500.

How does the repair of the 95910-F6200 work?

First have the fault memory read out and enclose the log. Then disconnect the battery and only then remove the control unit; afterwards create a repair order online and send the unit in well packed. At Airbag24, checking, repairing and testing usually take 3–4 working days.

For safety reasons this sequence must be observed. Airbag24 checks the unit on the test bench, finds the defective components and fixes them, erases the stored crash data and carries out a function test. Afterwards you receive your own, repaired unit back.

The 3–4 working days refer only to this work at Airbag24. Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-F6200 get to Airbag24?

You send the control unit 95910-F6200 as a parcel, or book a UPS collection for an extra charge. After the repair, Airbag24 returns it to you by UPS.

The printed repair order belongs in the parcel. Pack the unit shockproof so that it arrives undamaged.