Airbag control unit with part number 95910-G7100

What does the airbag control unit 95910-G7100 do?

The 95910-G7100 is the airbag control unit of the restraint system (SRS) in Hyundai. It evaluates the sensor data in an impact, determines the triggering of airbags and seatbelt pretensioners within milliseconds, and checks the system continuously.

Measurements from sensors flow continuously into the control unit, which derives the response from them.

In an accident the unit stores crash data and locks itself.

Why does the control unit 95910-G7100 fail?

Crash data from an accident is the most common cause on the 95910-G7100, even if no airbag was deployed. A standard diagnostic tool cannot erase it. Further possible causes are aged electronics, cold solder joints, moisture and corrosion at plug connections, and voltage spikes.

The crash data arises because the unit registers the incident, regardless of whether airbags were deployed.

Aged electronics and cold solder joints take effect as soon as the unit is under greater load.

Moisture and corrosion at plug connections, as well as voltage spikes, for example with a weak battery or jump-starting, put additional strain on the unit.

How can you tell that the 95910-G7100 is defective?

The airbag warning light in the instrument cluster stays on permanently or intermittently. An error message appears in the instrument cluster, the diagnostic tool finds no connection, and the fault memory cannot be cleared. On the 95910-G7100, airbags and seatbelt pretensioners may then not deploy in an emergency.

The following signs occur:

• Airbag warning light on permanently or intermittently
• Error message in the instrument cluster
• Diagnostic tool without a connection to the control unit
• Fault memory cannot be cleared

The warning light reports the defect itself, without any need for a diagnostic tool. Have the system checked promptly as soon as one of these signs appears.

Which vehicles is the 95910-G7100 fitted in?

The 95910-G7100 is fitted in these vehicles: Hyundai Ioniq AE Facelift (2019-2022) and AE (2016-2019). You can tell whether your model is included from this information before you remove the unit.

According to our information, these models match:

• Hyundai Ioniq AE Facelift (2019-2022)
• Hyundai Ioniq AE (2016-2019)

You should compare the part number on the unit with this page first; it only establishes identity. Whether the control unit or a plug or cable is the cause is shown by the fault memory read out beforehand.

For the same vehicles, we also repair control units with the part numbers 95910-G2000, 95910-G2400, 95910-G2500, 95910-G7400, G7959-10400.

How does the repair of the 95910-G7100 work?

For the 95910-G7100, have the fault memory read out first and enclose the log with the unit. Then disconnect the battery and only then remove the control unit. Create a repair order online and send the well-packed unit in; processing at Airbag24 usually takes 3–4 working days.

The work at Airbag24 begins with a check on the test bench. Defective components are then repaired, the crash data is erased and a function test follows, after which your own unit comes back to you.

The 3–4 working days only concern the work at Airbag24. Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-G7100 get to Airbag24?

You send the control unit 95910-G7100 as a parcel, or you book a UPS collection for an extra charge. The return after the repair follows by UPS.

Place the printed repair order in the parcel, and pack the control unit shock-resistant.