Airbag control unit with part number 95910-G9300

What does the airbag control unit 95910-G9300 do?

The 95910-G9300 is the airbag control unit, that is, the central control unit of the SRS restraint system in the Genesis. It processes the measurements from the crash sensors, determines in an instant which airbags and seatbelt pretensioners to trigger, and monitors the entire system without interruption.

If the system reports a fault, it appears via the airbag warning light on the dashboard. If an accident has occurred, the unit stores crash data and then locks itself.

The sensors supply measurements continuously, and the unit evaluates them without pause, so that no time is lost in an emergency.

Why does the control unit 95910-G9300 fail?

With the 95910-G9300, the most common cause is crash data stored after an accident, even without a triggered airbag; an ordinary diagnostic tool does not erase it. Added to this are aged components, cold solder joints, moisture and voltage spikes.

The crash data remain stored in the unit until they are removed during a repair. They are therefore the first thing to check, before components are suspected.

The other causes tend to act over time. Electronic components age, solder joints can go cold, and moisture and corrosion attack plug connections. Voltage spikes, for example from a weak battery or jump-starting, put additional strain on the electronics.

How can you tell that the 95910-G9300 is defective?

A defect in the 95910-G9300 shows up as the airbag warning light, as an error message in the instrument cluster, as a missing connection to the diagnostic tool or as a fault memory that cannot be cleared. In that case the airbags and seatbelt pretensioners may not deploy in an emergency.

The warning light in the instrument cluster is the clearest sign, because the unit triggers it itself. It can stay on permanently or appear only intermittently, and both call for a check.

If an error message or a diagnostic tool without connection is added, the suspicion grows. A prompt check then brings clarity.

Which vehicles is the 95910-G9300 fitted in?

The 95910-G9300 is fitted in these vehicles: Genesis G70 IK (from 2021). The details refer to the unit type and its assignment.

The following overview shows the vehicles in which this unit was installed:

• Genesis G70 IK (from 2021)

First compare the part number on the label of the removed unit with this page. This only confirms that it is the correct unit and does not yet explain any cause. Then have the fault memory read out, because only this shows whether the control unit is defective or whether a plug or cable is causing the problem.

How does the repair of the 95910-G9300 work?

First read out the fault memory and enclose the log, then disconnect the battery and only then remove the control unit 95910-G9300. Next, create a repair order online and send in the unit; at Airbag24 processing usually takes 3–4 working days.

The order is mandatory for safety reasons and is not shortened.

At Airbag24 the unit is checked on the test bench, defective components are replaced, stored crash data are erased and a function test is carried out. The 3–4 working days refer only to this work. Afterwards your own unit goes back to the sender.

Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-G9300 get to Airbag24?

You send the 95910-G9300 to Airbag24 as a parcel or book a UPS collection for an extra charge. The return after the repair also goes by UPS.

Enclose the printed repair order with the parcel and pack the unit shock-proof.