Airbag control unit with part number 95910-GI100

What does the airbag control unit 95910-GI100 do?

The airbag control unit 95910-GI100 is the central control of the restraint system (SRS) in Hyundai vehicles. It processes the data from the crash sensors, decides within milliseconds in a crash which airbags and seatbelt pretensioners are triggered, and checks the system without interruption. Faults are shown via the airbag warning light.

The evaluation must not fail in an emergency, which is why the unit is designed for continuous operation. The electronics run whether or not you are currently using the vehicle.

After a crash, the control unit stores crash data and locks itself.

Why does the control unit 95910-GI100 fail?

The most common cause is crash data stored after an accident, even if no airbag was triggered. A normal diagnostic tool cannot erase it. Other possible causes are aged electronic components, cold solder joints, moisture and corrosion at plug connectors, and voltage spikes, for example from a weak battery or a jump start.

The crash data remains in the memory even if the vehicle shows little external damage. An impact without a triggered airbag is enough for this.

Aged components and cold solder joints lead to faults that can recur during operation. Moisture and corrosion at the plugs intensify this problem.

Voltage spikes in the vehicle electrical system strain the electronics. A weak battery or a jump start are among the typical triggers.

How can you tell that the 95910-GI100 is defective?

The airbag warning light in the instrument cluster lights up permanently or intermittently, and a fault message appears in the instrument cluster. In addition, the diagnostic tool has no connection to the control unit, or the fault memory cannot be cleared. In this state, airbags and seatbelt pretensioners may possibly not trigger in an emergency.

The warning light is the most important sign. It informs you of a detected fault until the cause has been clarified.

A fault message in the instrument cluster confirms the fault. If the fault memory cannot be cleared, the finding remains.

Which vehicles is the 95910-GI100 fitted in?

The control unit 95910-GI100 is fitted in these vehicles: Hyundai Ioniq 5 NE (2021-2024) and NE Facelift (from 2024). The list below shows the individual models.

The vehicles at a glance:

• Hyundai Ioniq 5 NE (2021-2024)
• Hyundai Ioniq 5 NE Facelift (from 2024)

Comparing the part number on the label of the removed unit with this page tells you that it is the right unit. Before that, you should have the fault memory read out, because only this log shows whether the control unit is defective or whether a plug or cable is the cause.

For the same vehicles, we also repair control units with the part numbers 95910-GI110, 95910-PI600, 95910-PI610.

How does the repair of the 95910-GI100 work?

First have the fault memory read out and attach the log. Then disconnect the battery and only then remove the control unit. Create the repair order online and send the well-packed unit in. Airbag24 usually processes it within 3–4 working days.

This sequence is binding for safety reasons.

Airbag24 examines the unit on the test bench, replaces defective components, erases stored crash data and carries out a function test. Your own unit then goes back to you.

Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-GI100 get to Airbag24?

You send the unit in as a parcel, or you book a UPS collection for an extra charge. After the repair, Airbag24 sends it back to you by UPS.

Put the printed repair order in the parcel and pack the unit shock-proof.