Airbag control unit with part number 95910-GI250

What does the airbag control unit 95910-GI250 do?

The airbag control unit 95910-GI250 manages the SRS system for Hyundai. It processes the measurements of the crash sensors, decides in an accident within milliseconds on the triggering of the airbags and seatbelt pretensioners, and monitors the entire system.

Detected faults appear on the airbag warning light in the instrument cluster. After an accident it stores crash data and locks itself afterwards.

Why does the control unit 95910-GI250 fail?

The most common cause is stored crash data, and this applies even if no airbag was triggered in the accident. In addition, aged components, cold solder joints, corrosion and moisture as well as voltage spikes can lead to failure.

An ordinary diagnostic tool cannot erase this data. Airbag24 takes this over during the repair.

Voltage spikes arise, for example, from a weak battery or a jump start and can strain the electronics.

How can you tell that the 95910-GI250 is defective?

The airbag warning light in the instrument cluster stays on permanently or intermittently. In addition there is a message in the instrument cluster, a missing connection to the diagnostic tool and a fault memory that cannot be cleared. Airbags and seatbelt pretensioners may then possibly not trigger in an emergency.

If the light stays on after starting, have the system checked promptly.

Which vehicles is the 95910-GI250 fitted in?

The 95910-GI250 is fitted in these vehicles: Hyundai Ioniq 5 NE (2021-2024) and NE Facelift (from 2024).

The vehicles follow below in a list.

• Hyundai Ioniq 5 NE (2021-2024)
• Hyundai Ioniq 5 NE Facelift (from 2024)

If you compare the part number on the label of the removed unit with this page, you know that you have the right unit in front of you. The comparison confirms nothing more. Therefore have the fault memory read out before removal; only this result shows whether the control unit itself is defective or whether a connector or a cable is the cause.

For the same vehicles, we also repair control units with the part numbers 95910-GI110, 95910-PI600, 95910-PI610.

How does the repair of the 95910-GI250 work?

First have the fault memory read out and attach the log. Then disconnect the battery and only then remove the control unit. Create a repair order online and send the well-packed unit to Airbag24. Processing at Airbag24 usually takes 3–4 working days.

At the test bench Airbag24 checks the unit, replaces defective components and deletes the stored crash data. Finally a function test follows, and your unit, now repaired, goes back to you.

Our repairs come with 2 years' statutory liability for defects.

The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-GI250 get to Airbag24?

Either you send the control unit as a parcel, or you book a UPS collection for an extra charge. Airbag24 sends it back by UPS.

The printed copy of the repair order goes into the parcel, and you pack the unit shockproof.