Airbag control unit with part number 95910-GI710

What does the airbag control unit 95910-GI710 do?

In the Hyundai vehicle, the airbag control unit 95910-GI710 is the control unit of the restraint system (SRS). From the signals of the crash sensors, it calculates within milliseconds which airbags and seatbelt pretensioners to trigger in the event of an accident, and it monitors the system continuously. After an accident, it stores crash data and locks itself.

To do this, it constantly checks sensors, output stages and firing circuits. Every irregularity is recorded in the fault memory, which a workshop can read out later.

Why does the control unit 95910-GI710 fail?

The most common cause: crash data stored after an accident, even without a triggered airbag. Other causes include aged components, cold solder joints, moisture and corrosion on connectors, and voltage spikes.

Crash data stays in the unit, because a standard diagnostic tool is not sufficient to delete it. Airbag24 deletes it during the repair.

Aged electronics lose reliability over time. Moisture and corrosion affect connectors, and cold solder joints remain a weak point.

Voltage spikes, for example from a weak battery or a jump start, put additional strain on the circuits.

How can you tell that the 95910-GI710 is defective?

The airbag warning light stays on permanently or flickers, a fault message appears in the instrument cluster, the diagnostic tool finds no connection to the control unit, or the fault memory cannot be cleared. In a crash, airbags and seatbelt pretensioners may then fail to deploy.

A fault in the restraint system is shown by the warning light, regardless of how the vehicle feels.

If there is no connection to the diagnostic tool, the cause does not necessarily lie in the control unit. Wiring or a connector may also be responsible, which is why only the readout provides clarity.

Which vehicles is the 95910-GI710 fitted in?

The control unit 95910-GI710 is fitted in these vehicles: Hyundai Ioniq 5 NE (2021-2024) and NE Facelift (from 2024).

The vehicles are listed below in overview.

• Hyundai Ioniq 5 NE (2021-2024)
• Hyundai Ioniq 5 NE Facelift (from 2024)

Comparing the label on your removed unit with this page confirms that you have the right unit. The condition of the control unit itself, however, is revealed only by the fault memory. Have it read out before removal, because a connector or a cable can cause the same symptoms.

For the same vehicles, we also repair control units with the part numbers 95910-GI110, 95910-PI600, 95910-PI610.

How does the repair of the 95910-GI710 work?

First, the fault memory is read out, and the log goes into the package. Then disconnect the battery, and only afterwards remove the control unit. Next, create a repair order online and send the well-packed unit.

At Airbag24, the unit is first checked. This is followed by replacing defective components, deleting the crash data and the function test. Processing usually takes 3–4 working days before your own unit is sent back.

The sequence protects you from hazards in the airbag system. Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-GI710 get to Airbag24?

You can send the unit as a package, or arrange a UPS collection for an extra charge. The return after the repair is also made by UPS.

A printed repair order belongs in the package, and pack the unit so that it withstands knocks.