Airbag control unit with part number 95910-H6100

What does the airbag control unit 95910-H6100 do?

The airbag control unit 95910-H6100 controls the restraint system (SRS) of Hyundai. It evaluates the signals from the crash sensors and decides in an accident, within milliseconds, which airbags and seatbelt pretensioners are triggered.

The unit monitors the system continuously during operation. It reports faults via the airbag warning light in the instrument cluster.

After an accident, it stores crash data and locks itself. Only the repair lifts this lock.

Why does the control unit 95910-H6100 fail?

The most common cause is crash data stored after an accident, even if no airbag was triggered. Other causes are aged components, cold solder joints, moisture and corrosion at plug connectors, and voltage spikes on the 95910-H6100.

Crash data cannot be erased with a normal diagnostic tool. It stays stored even if the airbags did not trigger at all.

The other causes concern the electronics and their connections. Components age, solder joints can go cold, and moisture attacks plug connectors. Voltage spikes, for example from a weak battery or jump-starting, can damage the electronics.

How can you tell that the 95910-H6100 is defective?

A defect shows up as the airbag warning light staying on permanently or intermittently, and as a fault message in the instrument cluster. The diagnostic tool gets no connection to the control unit, and the fault memory cannot be cleared.

In that case, airbags and seatbelt pretensioners may not trigger in an emergency. A lit warning light should therefore not be ignored.

Even a warning light that comes on only briefly is a sign you should have checked.

Which vehicles is the 95910-H6100 fitted in?

The control unit 95910-H6100 is fitted in these vehicles: Hyundai Elantra AD.

The following overview shows the vehicles stored for this unit:

• Hyundai Elantra AD

Compare the part number on the label of the removed unit with this page. This only confirms that you have the correct unit in front of you.

Have the fault memory read out beforehand. Only the result shows whether the control unit is defective or whether a plug or a cable is the cause.

For the same vehicles, we also repair control units with the part numbers 3X959-10100, 95910-28510, 95910-28520, 95910-2D500, 95910-3X100, 95910-A5150.

How does the repair of the 95910-H6100 work?

First have the fault memory read out and enclose the log. Then disconnect the battery and only then remove the control unit. Processing at Airbag24 usually takes 3–4 working days.

This period only applies to checking, repairing and testing at Airbag24. Afterwards you create a repair order online and send the unit in, well packed.

Airbag24 checks the unit on the test bench, replaces defective components, erases the stored crash data and carries out a function test. Your own unit then goes back to you.

Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-H6100 get to Airbag24?

You send the control unit 95910-H6100 in as a parcel or book a UPS collection for an extra charge. After the repair, Airbag24 returns it to you by UPS.

Place the printed repair order in the parcel and pack the unit shock-proof.