Airbag control unit with part number 95910-H8110

What does the airbag control unit 95910-H8110 do?

The airbag control unit 95910-H8110 coordinates the restraint system (SRS) in Kia vehicles: it reads the crash sensors, decides in a crash which airbags and seatbelt pretensioners are triggered, and reports faults via the airbag warning light.

An impact is evaluated within milliseconds. System monitoring, by contrast, runs continuously even during normal driving.

After an accident, the unit stores crash data and locks itself.

Why does the control unit 95910-H8110 fail?

With the 95910-H8110, the most common cause after an accident is stored crash data, even without a triggered airbag. Further causes are aged components, cold solder joints, moisture and corrosion at plugs, and voltage spikes.

A standard diagnostic tool cannot reach this data. Airbag24 erases the crash data as part of the repair.

Voltage spikes occur, for example, with a weak battery or when jump-starting. Aging and moisture act slowly, and corrosion at plug connections can also cause faults.

How can you tell that the 95910-H8110 is defective?

A defect in the 95910-H8110 shows through an airbag warning light that burns permanently or intermittently, an error message in the instrument cluster, a missing connection to the diagnostic tool, or a fault memory that cannot be cleared.

If the control unit is faulty, airbags and seatbelt pretensioners may not trigger in an emergency. A warning light therefore calls for a prompt check.

The light itself does not reveal whether the control unit or a wire is affected.

Which vehicles is the 95910-H8110 fitted in?

The control unit 95910-H8110 is fitted in these vehicles: Kia Stonic YB (from 2017); Kia Rio YB (from 2017).

We list the following vehicles for this control unit:

• Kia Stonic YB (from 2017)
• Kia Rio YB (from 2017)

Comparing the part number on the label of the removed unit with this page shows you that you have the right unit. Have the fault memory read out beforehand, because only this result shows whether the control unit is defective or a plug or cable is the cause.

For the same vehicles, we also repair control units with the part numbers 95910-H8210, 95910-H8330, 95910H9430.

How does the repair of the 95910-H8110 work?

First have the fault memory read out and enclose the log. Then disconnect the battery and then remove the control unit 95910-H8110. You then create a repair order online and send the unit in well packed.

Airbag24 checks the unit on the test bench, replaces defective components, erases stored crash data and tests the function. Processing at Airbag24 usually takes 3–4 working days. Afterwards, your own unit is returned to you.

Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-H8110 get to Airbag24?

You can send the control unit 95910-H8110 in as a parcel or have it collected by UPS for an extra charge. After the repair, Airbag24 sends it back to you by UPS.

The printed repair order goes into the parcel, and the unit is packed shockproof.