Airbag control unit with part number 95910-J3200

What does the airbag control unit 95910-J3200 do?

The airbag control unit 95910-J3200 is the control unit of the SRS system of Hyundai. It evaluates the crash sensors, determines in an impact, within milliseconds, the triggering of airbags and seatbelt pretensioners, and checks the system continuously. It shows faults via the airbag warning light.

The control unit works in the background and stays invisible in everyday life. Only in the event of a fault does a display appear, and you recognise the state from the light in the instrument cluster.

After an accident, the unit stores crash data and locks itself, and only the repair lifts this lock.

Why does the control unit 95910-J3200 fail?

Stored crash data is the most common cause of a failure of 95910-J3200, even without a triggered airbag. Further causes are aged electronic components, cold solder joints, moisture and corrosion at plug connections, and voltage spikes.

A normal diagnostic tool cannot erase the crash data. Airbag24 erases them during the repair.

Weak batteries and jump-starting cause voltage spikes that strain the electronics. Moisture and corrosion additionally disturb the contact at plugs, while aged components become prone to faults over time.

How can you tell that the 95910-J3200 is defective?

A defect on the 95910-J3200 can be recognised by these signs, which you may notice in the instrument cluster or on the diagnostic tool.

• airbag warning light in the instrument cluster lights up permanently or intermittently
• error message in the instrument cluster
• diagnostic tool receives no connection to the control unit
• fault memory cannot be cleared

Airbags and seatbelt pretensioners may then fail to deploy in an emergency. The light is therefore not a cosmetic issue but a signal that you should take seriously.

Which vehicles is the 95910-J3200 fitted in?

A check against your vehicle shows whether the control unit fits. The airbag control unit 95910-J3200 is fitted in these vehicles: Hyundai Veloster JS (2018-2022).

The list of vehicles in which this control unit has been installed follows here:

• Hyundai Veloster JS (2018-2022)

Compare the part number on the label of the unit with this page. That only confirms that it is the right unit. Also have the fault memory read out, because only the result shows whether the control unit is defective or whether a plug or cable is the cause.

For the same vehicles, we also repair control units with the part numbers 95910-K9000.

How does the repair of the 95910-J3200 work?

For the 95910-J3200, you first read out the fault memory and attach the log. Then you disconnect the battery, and only then remove the unit. You create the repair order online. Checking, repairing and testing take 3–4 working days at Airbag24 as a rule.

After that, send in the well-packed unit. Airbag24 checks it on the test bench, replaces defective components, erases stored crash data and carries out a function test. Then your own unit goes back to you.

Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-J3200 get to Airbag24?

The control unit 95910-J3200 reaches Airbag24 as a parcel, or you book a UPS collection for an extra charge. After the repair, UPS brings the unit back to you.

The printed repair order is in the parcel, and the unit is packed shock-proof.