Airbag control unit with part number 95910-Q6700

What does the airbag control unit 95910-Q6700 do?

The 95910-Q6700 controls the airbags and seatbelt pretensioners in the restraint system (SRS) of Kia. In an accident it decides within fractions of a second whether to trigger them and monitors the system continuously. Detected faults are shown via the airbag warning light.

The sensor data flows into the evaluation constantly, so that the unit can react at any time.

An accident leaves its mark: the unit stores crash data and locks itself afterwards.

Why does the control unit 95910-Q6700 fail?

On the 95910-Q6700 the most common cause is an entry with crash data, even if no airbag was triggered; normal diagnostic tools cannot remove it. In addition, aged components, cold solder joints, moisture and corrosion, as well as voltage spikes, can cause a failure.

Crash data cannot be removed with usual means; Airbag24 eliminates it during the repair.

Cold solder joints and aged components affect the function gradually.

Current and voltage fluctuations caused by a weakened battery or a jump start are also possible triggers. Moisture and corrosion on plugs disturb the contact.

How can you tell that the 95910-Q6700 is defective?

A defective 95910-Q6700 gives itself away through the airbag warning light in the instrument cluster, which lights up permanently or intermittently. It is accompanied by faults in the instrument cluster, a diagnostic tool without connection, and a fault memory that cannot be cleared. Airbags and seatbelt pretensioners may then not be reliably active in an emergency.

The signs at a glance:

• airbag warning light on permanently or intermittently
• error message in the instrument cluster
• diagnostic tool does not reach the control unit
• fault memory cannot be cleared

If any of these signs appears, have the cause narrowed down promptly.

Which vehicles is the 95910-Q6700 fitted in?

The Kia vehicles in the assignment show where the unit is used. The 95910-Q6700 is fitted in these vehicles: Kia Seltos SP2 (from 2019).

These vehicles are recorded:

• Kia Seltos SP2 (from 2019)

Before the unit is removed, compare the part number on the label with this page. It only confirms that the unit is the correct one. Whether the control unit is defective or a plug or cable causes the fault is shown only by the fault memory read out beforehand.

For the same vehicles, we also repair control units with the part numbers 80100-Q5600WK, 80100Q5600, 95910-Q5100-95512.

How does the repair of the 95910-Q6700 work?

Have the fault memory read out first and enclose the log, then disconnect the battery and remove the 95910-Q6700. Then create the repair order online and send the unit in well packed. Airbag24 needs 3–4 working days in general for checking, repairing and testing.

Airbag24 checks the unit on the test bench, removes defective components, deletes the stored crash data and carries out a function test. Afterwards your own unit is returned.

Our repairs come with 2 years' statutory liability for defects.

The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-Q6700 get to Airbag24?

The 95910-Q6700 comes to Airbag24 as a parcel, or you book a UPS collection for an extra charge. After the repair, Airbag24 brings it back by UPS.

Make sure to enclose the repair order printed out, and pack the unit shock-proof.