Airbag control unit with part number 95910-R2410

What does the airbag control unit 95910-R2410 do?

The airbag control unit 95910-R2410 controls the restraint system (SRS) of Kia. From the signals of the crash sensors it works out within milliseconds which airbags and seatbelt pretensioners are triggered in an impact.

Monitoring runs continuously during operation. The unit outputs detected faults via the airbag warning light in the instrument cluster.

After an accident it stores crash data and locks itself.

Why does the control unit 95910-R2410 fail?

The most common cause is crash data from an accident, even if no airbag was deployed, which cannot be cleared with a usual diagnostic tool. Further causes are ageing components, cold solder joints, moisture and corrosion at plug connections, and voltage spikes.

The crash data remains after the event, regardless of whether an airbag has deployed.

Ageing components and cold solder joints are among the causes from the electronics themselves. Moisture and corrosion attack the plug connections, which can lead to faults.

Voltage spikes, for example from a weak battery or from a jump start, are also a possible cause.

How can you tell that the 95910-R2410 is defective?

Signs of a defect are an airbag warning light that lights up permanently or intermittently, an error message in the instrument cluster, no contact between the diagnostic tool and the control unit, and a fault memory that cannot be cleared. In an emergency, airbags and seatbelt pretensioners may then fail to deploy.

• Airbag warning light in the instrument cluster permanently or intermittently on
• Error message in the instrument cluster
• Diagnostic tool cannot reach the control unit
• Fault memory remains

As soon as any of these signs appear, you should have the vehicle checked.

Which vehicles is the 95910-R2410 fitted in?

The control unit 95910-R2410 is fitted in these vehicles: Kia Sportage NQ5 (from 2021).

Use of this unit in the following vehicles is known:

• Kia Sportage NQ5 (from 2021)

If the part number on the label of the removed unit matches this page, that only confirms that it is the right unit. You should have the fault memory read out beforehand, because only it shows whether the control unit is defective or whether a plug or a cable is the cause.

For the same vehicles, we also repair control units with the part numbers 95910-3U600, 95910-D9000, 95910-R2310, 959100Z200.

How does the repair of the 95910-R2410 work?

The process starts with reading out the fault memory, and the log goes with the unit. Then you disconnect the battery, and only after that is the control unit removed. Finally, you create the repair order online and send the unit in well packed. At Airbag24, testing, repair and function test usually take 3–4 working days.

Airbag24 examines the unit on the test bench, replaces defective components and deletes the stored crash data. A function test follows, after which your own unit is returned to you.

Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-R2410 get to Airbag24?

For the route to Airbag24 you can choose between a parcel or a UPS collection for an extra charge. After the repair the unit comes back by UPS.

Put the printed repair order in the parcel and pack the control unit shock-proof.