Airbag control unit with part number 95910-S3000

What does the airbag control unit 95910-S3000 do?

The airbag control unit 95910-S3000 controls the restraint system (SRS) in Hyundai. It evaluates the crash sensors, decides within milliseconds in an accident whether airbags and seatbelt pretensioners are triggered, and stores crash data after an accident. It then locks itself.

The unit monitors the system constantly. Faults appear via the airbag warning light in the instrument cluster.

The lock only ends with the repair.

Why does the control unit 95910-S3000 fail?

For the 95910-S3000, the most common cause is crash data stored after an accident, even if no airbag was deployed. Other causes are aged electronic components, cold solder joints, moisture and corrosion at plug connections, and voltage spikes.

Crash data cannot be erased with a standard diagnostic tool, so it stays stored.

Aged components and cold solder joints can impair the electronics. Moisture and corrosion attack the plug connections.

Voltage spikes, for example from a weak battery or a jump start, put additional strain on the unit.

How can you tell that the 95910-S3000 is defective?

The signs on the 95910-S3000 are the airbag warning light in the instrument cluster, which lights up permanently or intermittently, and an error message in the instrument cluster. In addition, the diagnostic tool may have no contact with the control unit, or the fault memory cannot be cleared.

• Airbag warning light in the instrument cluster lights up permanently or intermittently
• Error message in the instrument cluster
• Diagnostic tool has no connection to the control unit
• Fault memory cannot be cleared

Airbags and seatbelt pretensioners may not deploy in an emergency. Have the warning checked promptly.

Which vehicles is the 95910-S3000 fitted in?

The airbag control unit 95910-S3000 is fitted in these vehicles: Hyundai Santa Fe TM Facelift (2020-2024).

The vehicles at a glance:

• Hyundai Santa Fe TM Facelift (2020-2024)

(a) Compare the part number on the label of the removed unit with this page; this only confirms that you have the right unit in front of you. (b) Have the fault memory read out beforehand, because only the result shows whether the control unit is defective or whether a connector or cable is the cause.

For the same vehicles, we also repair control units with the part numbers 95910-2B600, 95910-2B610, 95910-2B620, 95910-2B650, 95910-2B970.

How does the repair of the 95910-S3000 work?

For the 95910-S3000, first read out the fault memory, enclose the log and disconnect the battery. Only then remove the control unit. Next, create a repair order online. Processing at Airbag24 usually takes 3–4 working days.

Pack the unit well and send it in.

Airbag24 checks it on the test bench, repairs defective components, erases stored crash data and carries out a functional test. The unit then goes back to you. Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-S3000 get to Airbag24?

You send the control unit 95910-S3000 as a parcel or book a UPS collection for an extra charge. After the repair, Airbag24 returns it by UPS.

Put the printed repair order into the parcel and pack the unit shockproof.