Airbag control unit with part number 95910-S8620

What does the airbag control unit 95910-S8620 do?

The airbag control unit 95910-S8620 evaluates the crash sensors and forms the centre of the restraint system (SRS) for Hyundai. In an accident it decides within milliseconds which airbags and seatbelt pretensioners trigger.

It also monitors the system without interruption and shows faults via the airbag warning light in the instrument cluster.

An accident causes the unit to record crash data and lock itself.

Why does the control unit 95910-S8620 fail?

The most common cause for the 95910-S8620 is crash data from an accident, even if no airbag fired. Further causes are aged components, cold solder joints, moisture and voltage spikes.

Crash data remains stored in the control unit regardless of whether airbags were triggered. Everyday diagnostic tools cannot remove it; Airbag24 takes care of this during the repair.

Aged electronic components and cold solder joints are further causes that make themselves felt over time.

Moisture and corrosion at plug connections, as well as voltage spikes, for example with a weak battery or jump-starting, round off the picture.

How can you tell that the 95910-S8620 is defective?

A defect in the 95910-S8620 can be recognised by several signs, above all the airbag warning light.

Watch for these signs:

• The warning light in the instrument cluster stays on permanently or only intermittently.
• An error message appears in the instrument cluster display.
• A reading tool cannot reach the control unit.
• Entries in the fault memory remain.

In an emergency, airbags and seatbelt pretensioners may fail to trigger. The finding is therefore a reason to have the vehicle checked promptly.

Which vehicles is the 95910-S8620 fitted in?

These vehicles use the 95910-S8620: Hyundai Palisade LX2 Facelift (2022-2025) and LX2 (2018-2022).

The list in detail:

• Hyundai Palisade LX2 Facelift (2022-2025)
• Hyundai Palisade LX2 (2018-2022)

Comparing the part number on the label with this page confirms that the removed unit matches the page. You should have the fault memory read out in advance. The reading shows whether the control unit itself is at fault or a connector or cable behind it.

For the same vehicles, we also repair control units with the part numbers 95910-S8520, 95910-S8530.

How does the repair of the 95910-S8620 work?

Before anything else comes the fault memory: read it out, attach the log, then disconnect the battery and remove the 95910-S8620. Processing at Airbag24 usually takes 3–4 working days.

Then create a repair order online and send the unit off well packed.

Defective components are repaired at Airbag24, crash data deleted, and a function test checks the result. Then you get your unit back.

The removal takes place only after the other steps, for safety. Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-S8620 get to Airbag24?

Sending is either by parcel through you, or by a UPS collection that you book for an extra charge. After the repair, Airbag24 returns the repaired 95910-S8620 to you by UPS.

Put the printed repair order into the parcel and pack the unit well so it arrives shock-resistant.