Airbag control unit with part number 95910T1100

What does the airbag control unit 95910T1100 do?

The airbag control unit 95910T1100 is the central control of the SRS in Genesis vehicles. It processes the signals from the crash sensors, determines in an accident within milliseconds which airbags and seatbelt pretensioners fire, and monitors the system continuously.

The unit stores faults and displays them via the airbag warning light. This is how the driver learns that something is wrong in the restraint system.

After an accident, the control unit creates crash data and locks itself. This function is part of the design.

Why does the control unit 95910T1100 fail?

Most often it is caused by crash data from an earlier accident, even if no airbag has deployed; a normal diagnostic tool cannot erase it. In addition, the 95910T1100 has further causes such as ageing, corrosion and voltage spikes.

• aged electronic components
• cold solder joints
• moisture at plugs, combined with corrosion
• voltage spikes, for example from jump-starting

A vehicle that drives normally again after an accident still has crash data in its memory. Airbag24 removes it during the repair.

The other causes cannot be reliably told apart without testing.

How can you tell that the 95910T1100 is defective?

Typical signs of a defect in the 95910T1100 are an airbag warning light that stays on permanently or from time to time, an error message in the instrument cluster and a diagnostic tool without contact. A fault memory that cannot be emptied also points to a defect. In an emergency, airbags and seatbelt pretensioners may then fail to deploy.

• Airbag warning light stays on permanently or from time to time
• Error message in the instrument cluster
• No contact between diagnostic tool and control unit
• Fault memory cannot be cleared

The warning light shows the defect. A check is therefore advisable as soon as the light stays on permanently.

Having the fault memory read out is the first sensible step.

Which vehicles is the 95910T1100 fitted in?

The control unit 95910T1100 is fitted in these vehicles: Genesis G80 RG3 (2021-2023) and RG3 Facelift (from 2024).

The overview lists the vehicles recorded for this part number.

• Genesis G80 RG3 (2021-2023)
• Genesis G80 RG3 Facelift (from 2024)

Comparing the part number on the label with this page only confirms that it is the correct unit. Have the fault memory read out beforehand, because it shows whether the control unit itself is affected or a plug or cable is the cause.

For the same vehicles, we also repair control units with the part numbers 95910T1000, 95910T1010.

How does the repair of the 95910T1100 work?

At Airbag24 processing usually takes 3–4 working days. There the unit is examined on the test bench, defective components are repaired, crash data is erased and a function test is run.

Before sending, have the fault memory read out and enclose the log. Then disconnect the battery and remove the control unit. Only afterwards do you create the repair order online and send in the well-packed unit.

At the end you receive your own unit back.

Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910T1100 get to Airbag24?

Delivery of the 95910T1100 to Airbag24 is by parcel or by UPS collection for an extra charge. Return shipping after the repair is by UPS.

The printed repair order goes into the parcel, and the unit needs shockproof packaging.