Airbag control unit with part number 95910T6200

What does the airbag control unit 95910T6200 do?

The airbag control unit 95910T6200 is the central unit of the restraint system (SRS) of Genesis. It evaluates the sensors, decides within milliseconds on the triggering of airbags and seatbelt pretensioners, and monitors the system continuously.

It indicates faults via the airbag warning light in the instrument cluster.

After an accident, the unit stores crash data and locks itself.

Why does the control unit 95910T6200 fail?

The most common cause with the 95910T6200 is stored crash data after an accident, even if no airbag has been triggered. Further causes are aged electronic components, cold solder joints, moisture and corrosion at plug connections, and voltage spikes.

Crash data remains in the unit after an accident, even without a triggered airbag. An ordinary diagnostic tool cannot erase it; Airbag24 removes it during the repair.

The other causes lie in the electronics and their connections. Moisture, corrosion and cold solder joints impair the contact, aged components give way, and voltage spikes arise, for example, from a weak battery or jump-starting.

How can you tell that the 95910T6200 is defective?

The airbag warning light in the instrument cluster lights up permanently or intermittently, and a fault message appears in the instrument cluster. In addition, the diagnostic tool cannot connect to the control unit, and the fault memory cannot be cleared.

The warning light reports the defect as soon as the system detects it. It therefore shows that something is wrong in the system.

In an emergency, airbags and seatbelt pretensioners may not be able to trigger with such a defect.

In which vehicles is the 95910T6200 fitted?

The assignment is based on the data for this part number. The control unit 95910T6200 is fitted in these vehicles: Genesis GV80 JX1 (2021-2023) and JX1 Facelift (from 2024).

The models in detail:

• Genesis GV80 JX1 (2021-2023)
• Genesis GV80 JX1 Facelift (from 2024)

Before removal, compare the part number on the label with this page. This only confirms that it is the correct unit. Also have the fault memory read out beforehand, because only the result shows whether the control unit is defective or a connector or cable is the cause.

For the same vehicles, we also repair control units with the part numbers 95910T6100.

How does the repair of the 95910T6200 work?

First read out the fault memory and attach the log, then disconnect the battery. Afterwards, remove the control unit and create a repair order online before sending in the well-packed unit. At Airbag24, testing, repair and function test usually take 3–4 working days.

The test is carried out on the test bench. Airbag24 then replaces defective components, deletes the crash data and tests the function.

At the end, you receive your own unit back.

Our repairs come with 2 years' statutory liability for defects.

The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910T6200 get to Airbag24?

You send the unit to Airbag24 as a parcel, or you book a UPS collection for an extra charge. After the repair, the unit is returned to you by UPS.

The printed repair order belongs in the packaging, and the packaging must be shock-proof.