Airbag control unit with part number 95910-2J810

What does the airbag control unit 95910-2J810 do?

The control unit 95910-2J810 belongs to the restraint system (SRS) of Kia. It evaluates the signals from the crash sensors, determines in an accident within milliseconds which airbags and seatbelt pretensioners are triggered, and monitors the system continuously. After an accident it stores crash data and locks itself.

It reports faults via the airbag warning light in the instrument cluster.

Why does the control unit 95910-2J810 fail?

Most often the cause is crash data stored after an accident, even if no airbag was deployed. A standard diagnostic tool cannot erase this data; Airbag24 erases it during the repair. Other causes lie in ageing, poor contacts, environmental influences and voltage fluctuations.

• ageing of the electronic components
• cold solder joints on the circuit board
• moisture and corrosion in plug connections
• voltage spikes, for example from a weak battery or a jump start

Which of these applies in an individual case is determined only by testing the unit.

How can you tell that the 95910-2J810 is defective?

A defect becomes visible through the airbag warning light in the instrument cluster, which stays on permanently or only intermittently. A fault message may accompany it, the diagnostic tool finds no connection to the control unit, or the fault memory cannot be emptied. Airbags and seatbelt pretensioners may then fail to deploy in an emergency.

This light is the designated display for exactly such faults and must therefore be taken seriously.

A diagnostic tool reads the fault memory, provided it can establish a connection to the control unit.

Which vehicles is the 95910-2J810 fitted in?

The 95910-2J810 is fitted in the following vehicles: Kia Mohave HM (2008-2024).

The vehicle overview is as follows:

• Kia Mohave HM (2008-2024)

On the one hand, matching the number on the label of the removed unit confirms that it fits this page. On the other hand, only the fault memory read out beforehand shows whether the control unit itself is defective or whether a connector or cable is the cause.

For the same vehicles, we also repair control units with the part numbers 95910-2J400, 95910-2J450, 95910-2J550, 95910-2J580.

How does the repair of the 95910-2J810 work?

You read out the fault memory first, and the log goes with it. Then disconnect the battery, only afterwards remove the control unit, and create the repair order online. At Airbag24, testing, repair and the function test usually take 3–4 working days.

Send the unit off well packed. At Airbag24 it goes onto the test bench, defective components are replaced, stored crash data is erased and a function test follows. Afterwards you receive your unit back.

Our repairs come with 2 years' statutory liability for defects. The repaired control unit comes back with all vehicle data and is ready for use as soon as it is refitted — no coding or programming is required.

How does the control unit 95910-2J810 get to Airbag24?

Either you post the unit as a parcel, or you book a UPS collection for an extra charge. Airbag24 sends it back to you by UPS after the repair.

The printed repair order is in the parcel, and the control unit itself is packed shockproof.