What is a Pontiac Grand Am 1992-1998 airbag control module?
The Pontiac Grand Am 1992-1998 airbag control unit is your vehicle's central safety unit, responsible for monitoring and activating all occupant restraint systems. It registers crash signals from sensors, stores accident data, and ensures the proper functioning of the airbags and seatbelt pretensioners for your safety.
This module, also known as the SRS SDM (Sensing Diagnostic Module), forms the heart of the passive safety system. It coordinates emergency activation based on incoming sensor data.
A defective airbag control unit can impair the entire airbag functionality and must be repaired immediately to restore full driving safety.
Why is the Pontiac Grand Am 1992-1998 airbag control module defective?
A 1992-1998 Pontiac Grand Am airbag control unit often fails because it stores crash data after an accident and then becomes locked. Internal electronic errors, short circuits, or moisture ingress can also cause a failure, causing the airbag warning light to stay illuminated and the system to stop functioning.
Often, the defect is due to a faulty power supply or a grounding issue that disrupts the module's communication. A professional diagnosis is essential to identify the exact cause.
Such internal problems require specialized repair because they impair the basic functionality of the airbag system. Without repair, the system may not deploy properly in an emergency.
Common error codes for Pontiac Grand Am 1992-1998 airbag control unit repair
When repairing the Pontiac Grand Am 1992-1998 airbag control module, specific B-codes are crucial. They signal direct problems with the module itself. These error codes indicate internal defects, communication failures, or malfunctions in the control module electronics that require immediate repair to ensure safety.
- B1000 → Control unit communication error → Signal loss or open circuit in the module.
- B1001 → Short circuit in the control unit → Internal electrical overload or damaged components.
- B1002 → Open circuit in the control unit → Broken internal connection or defective component.
- B1003 → Interruption in the diagnostic channel → Missing data transmission to the diagnostic device.
- B1004 → EEPROM error in the control unit → Damaged data memory in the module.
- B1010 → Internal memory error in the airbag module → Corrupt data or defective memory chip.
- B1020 → Airbag control unit internal self-test failed → The module detects an internal error.
- B1100 → Power supply or ground problem at the control unit → Insufficient voltage or missing ground connection.
- B1102 → Data bus communication problem control unit → interruption of the data line to the bus.
- B1110 → Software error in the airbag control unit → Corrupt firmware or programming error.
What part numbers are available for the Pontiac Grand Am 1992-1998 airbag control unit repair?
For Pontiac Grand Am 1992-1998 airbag control module repair, the OEM part numbers 16238589 and the alternative 09369720 are primarily relevant. These numbers identify the specific SRS SDM module that must be installed in your vehicle for proper function, compatibility, and safety.
The number 16238589 is the primary confirmed original OEM part number for this airbag control unit. It has been verified for Pontiac Grand Am models from 1992 to 1998.
Part number 09369720 serves as a recognized alternative or replacement part number for the same module. Both numbers are crucial for correct assignment during a repair.
It is imperative that the part number of your defective module matches that of the replacement part. This is the only way to ensure successful restoration of airbag function after repair.
These modules were typically manufactured by Delphi, a GM OEM supplier, and are VIN-coded for each vehicle. Precise identification by part number avoids compatibility issues.